Fredwin Cycling knowledge base

Record an activity

With just a few taps, you can record your distance, speed, elevation, and route information β€” so you can keep a detailed log of your cycling history. Read on to learn all about recording activities in Fredwin Cycling.

Record an activity

  • Tap Record from the bottom navigation menu to get to the recording screen.

  • To begin recording, tap the Start button near the bottom of the screen.

  • If recording a GPS-based activity, you can toggle between the map and stats displays by tapping the pin icon πŸ“Œ.

Embedded whiteboard

Tap the gear βš™οΈ icon in the upper right-hand corner of the record screen to access controls for the following:

  • Display Settings β€” choose to prevent the screen from turning off while recording. If you use an Android device, this will be under Screen Display.

  • Audio Cues can be enabled for the activity start/stop/pause and riding splits.

  • Enable auto-pause for hands-free pausing. Leave auto-pause off, and we will calculate your moving time when the activity uploads to our server.

  • Use the new Fredwin Cycling Beacon to share your real-time location with up to four safety contacts.

  • Connect a heart rate sensor.

Top

Pause, save, or finish an activity

Tap the square stop πŸŸ₯ icon to pause your activity. If you need to remove time when you were not moving, you have a few options:

  • The app can auto-pause recording. We use GPS data or your phone's accelerometer to determine when you are resting.

  • If you turn off auto-pause and don't use manual pause, we will do all of our calculations on the server side after the activity is uploaded β€” using your GPS data to determine when you were resting.

It is unnecessary to pause your recording while stopped unless you'd like complete control over your moving time. You must be consistent about pausing if you go with this option.

Press the Finish button. Then Save your activity.

  • Title your activity, add photos, write a description, change your activity privacy controls, and more.

  • On iOS, tap Save Activity; if you are using an Android, the Save option will be located at the top right of your activity - and be aware that if you tap Discard Activity (and then confirm this choice) - there is no way for us to recover the activity.

  • Your activity will be uploaded to your feed immediately, and you'll be able to view the complete activity details after syncing is complete.

Top

Other recording features

  • Load a route by tapping on the routes icon in the bottom left-hand corner of the screen. Learn more.

  • Live stats (subscribers only) like speed, cadence, heart rate, and power will show real-time values instead of averages. Runs will use the current average split pace.

  • The GPS strength indicator is a halo around your location, indicating accuracy. The smaller the halo, the stronger the GPS signal.

Top

App data usage

While recording, there is only data usage if you view the maps or have Live Segments or Beacon turned ON. Otherwise, the app uses GPS while recording. Once you've finished recording, the app must transfer some data to sync the activity with the Fredwin Cycling servers. That's about 1MB for two hours of recording, but it can vary slightly. There will also be a small amount of data transfer to update your feed. Please note, however, that if you can wait for a WIFI connection to sync the activity or view the feed, you can prevent all cellular data usage.

Top

Have questions? Our support team is here to help. You can reach out to us anytime at support@fredwincycling.io β€” we'll respond right away!